These mounts tilt the motors 10 degrees forward AND 4 degrees to the center of the quad for stability at hover and at high speeds.
(ZMR250 frame, motors, and propellers not included). Included in this kit are:
- 10 degree calibration stand
- 10 degree motor mounts for 22xx class motors (16mm x 19mm M3 bolt pattern)
- sixteen (16) M3x8mm bolts
- sixteen (16) M2x10mm bolts
- sixteen (16) M2 nuts
- sixteen (16) M2 washers
(NOTE: Bolts may be stainless steel or black alloy, whichever is available at the time. Every attempt will be made to make sure all hardware is all stainless or black, but no guarantees can be made. All nuts and washers are stainless steel)
The motor mounts are angled at 10 degrees forward for FPV usage to keep your camera from pointing at the ground all the time AND 4 degrees to the center of the ZMR to provide stability.
Since motor tilts can break in accidents (protecting both the arm and the motor), an additional set of mounts with no hardware is suggested.
A $5 donation will be made to the Susan G Komen Breast Cancer foundation for each pink kit purchased.